MEP Options and Cables

Cable for External Triggering to/from an external device using 9p D-sub connector (e.g.
Keypoint EMG/EP system).
Connectors:
9p D-sub plug (MagPro) 9p D-sub plug (Keypoint) Cable length: 3 m

Cable for External Triggering to/from an external device using BNC connectors. Connectors:
9p D-sub plug (MagPro) 2 x BNC plug
Cable length: 3 m

Cable for External Triggering from one MagPro stimulator to second one. With this setup it is possible to have two magnetic coils connected and synchronized.
Connectors:
9p D-sub plug (MagPro master) 9p D-sub plug (MagPro slave)

Cable splitter for External Triggering of MagPro slave and to an external device (e.g. Keypoint EMG/EP system)
Connectors:
9p D-sub plug (MagPro master) 9p D-sub plug (MagPro slave) 9p D-sub plug (Keypoint)

Interface unit to be used by MagPro Compact only. The unit is mounted on the front of
MagPro Compact between the stimulator and the coil. The external power control is for coils without controls in the coil handle. Instead, the control is carried out from the external power control. Can be used on all coils except C-100, C-B60 and MMC-140-II. Note: MCF- and Cool coils are not supported.

Coil interface cable to be used with MagPro G3 and MagPro R20 only.
To minimize the mechanical stress on the small 4p Lemo connector on coils, when disconnection and reconnection of the coil to MagPro G3, an interface cable with the more robust 6p Lemo connector can be a solution.
For connections of supported coils with 4p Lemo connector to MagPro R20.

Spare part for Cool-B65 A/P and Cool D-B80 A/P coils

Shielded Electrode cable for MEP Monitor for Active, Reference and Ground electrodes.

Shielded Electrode cable for MEP Monitor for Active, Reference and Ground electrodes.

Foot switch is connected to the trigger connector on the MagPro R100. With the footswitch external trig can be generated to perform a single stimulation of start a protocol session line.

Foot switch is connected to the trigger connector on the MagPro R30 or X100. With the footswitch external trig can be generated to perform a single stimulation of start a protocol session line.

MagProbe is designed to provide information about the magnetic field from stimulating coils. The probe is useful as a simple tool for estimating the suitability of a specific coil, intended for a specific application. In addition, the probe enables the user to predict the
ability to stimulate at different locations in tissue, when using different coil positions.

1 channel EMG amplifier to be mounted on the back of the MagPro system. Measurement of Motor Evoked Potentials (MEP). Specially designed for determination of Motor Threshold. (HxWxD:) 184 x 94 x 40mm

Used for MEP recordings as Active, Reference and Ground electrode.

Used for MEP recordings as Active, Reference and Ground electrode.